Because this was such a large project, I got a little over involved and didn't take many notes on the parts & tools I used. This conversion does require welding & fabbing, so if you are considering doing this you should already have most of the tools necessary anyway.

So here are a few picture galleries:

The front hangar & install:
Gallery 1

The crossover steering from M.O.R.E.:
Gallery 2

More of the installation:
Gallery 3

Afterwards & some fine tuning:
Gallery 4

Some additional bracing to the stock LCA mounts:
Gallery 5


I'm very pleased with the setup & thrilled about the strength of my steering. I have no bumpsteer & it rides just as smooth as it did on the coils. One thing I plan on adding up front is a buggy spring setup for additional droop which should just about wrap this project up.